Looking for some suggestions. Would like to replace the section of floor from behind the rear seats to the trunk floor for a 67 fullsize Convertible. The section that goes over the differential hump. Looked at sheet metal suppliers like Cross Canada and Impala Bobs and can't seem to find anything.
The braces are also available. You attach the panel to the rear of the floor pan, then the trunk pan comes up to overlap onto the intemediate. Has flanged sides. Should probably have just replaced mine, it was that close. Still may as the trunk pan has to be done anyway.
Cheers, Mark.
-- Edited by cdnpont on Saturday 19th of December 2009 11:42:30 PM
67 2+2 Ragtop said
Dec 20, 2009
Thanks Mark,
You are a fountain of information!!!
I bought that frame that we were talking about the other day for $500. Very good shape.
The braces are also available. You attach the panel to the rear of the floor pan, then the trunk pan comes up to overlap onto the intemediate. Has flanged sides.
Should probably have just replaced mine, it was that close. Still may as the trunk pan has to be done anyway.
Cheers, Mark.
-- Edited by cdnpont on Saturday 19th of December 2009 11:42:30 PM
dale