Looking for ,1-SD hub cap (think they came on other models,years), 6 cyl PS pump brackets. Pic of cap Thx Jim

jmont64 wrote:

---

Will the power steering pump brackets be the same from the other sixes? Pretty sure I still have a set of them.

---

 Think so,if not I'll make them fit(BFH)! Just shoot me a PM (no cell yet).

StriperSS wrote:

---

If you get them from Jerel, I can bring them back for you!

---

 Thanks John..as you saw..not a major panic.

jmont64 wrote:

---

You have to take the engine too!

---

 Johns van looked pretty full!! Could always plunk it on the roof...just need a couple of good straps!

I've got some good straps. Is this similar to what you need?

Carl Stevenson wrote:

---

Jim, I'm quite sure the inside groove on the crank is always for alternator and water pump because manual steering cars would only use that groove. It's a long time since I had a 6 cylinder Acadian with power steering (1974, my first 65 SD, ripped out the 6 and put a V8 in of course!) but I'm quite sure that second groove on the alternator is just an idler for the PS belt.

---

 Thx Carl,I'll see if mine is a single or double. Your a lot more help than Jonhnee!

DANO65 wrote:

---

Hey Jim, I have the whole set up still attached to the rusted boat anchor original engine from the Acadian, I'll take a pic and post it tonight.
Yeah I know, still haven't got around to putting it all on the " new" engine........

---

 Thanks a lot Dan,but think I've got everything  that I need from coming Jerel. Wont you need it for the "new" engine or are going V8,tunnel ram,twin carb setup for her?

Carl Stevenson wrote:

---

I think he is just saying he will show you what it should look like Jim.

---

 Was only my first cup of coffee...takes two till I can think straight!

Carl Stevenson wrote:

---

I think he is just saying he will show you what it should look like Jim.

---

 Yeah what he said. Just want to make sure the Beaumont stuff is the same as Acadian.

Now go have another cup or 2 and get back to work Jim.

Well the brackets are different but look to put the pump in the same spot. So probably will work.

DANO65 wrote:

---

Well the brackets are different but look to put the pump in the same spot. So probably will work.

__________________________________________________________________________________________________________________________________________

 

Thanks for the pics buddy! Think the one's from Jerel will work or can make work with a BFH! Now I have something to refer to.  Whens the trip out West?????? Time to re-pay!!  You were right when you said rusted..looks like the belt might handle a couple more revolutions..but just a couple!