I was wondering if anyone has any advice,templates or
great ideas to install fender badges on fenders that dont have the proper holes from the factory
the car is a 67 Parisienne badges are the Parisienne script and the v8 script
left and right front fender
Thank Greg
hawkeye5766 said
Jul 7, 2018
Put masking tape on area to be drilled(will help with chipping the paint), also works well for marking/laying out where to drill.
koolconvertible said
Jul 8, 2018
Get som flat styrofoam, put a sheet of paper on top, tap down firmly, get badge, push down through paper and into foam and voila! A hole drilling guide. Masking tape on car once position marked, use guide, light centre pop, use small drill to start with then drill to size.
NOS said
Jul 8, 2018
I think he may have needed the proper position of the emblems ??
Dale @ NOS
koolconvertible said
Jul 9, 2018
Probably best to get measurments and reference points from an existing car for positioning on the panel.
SGS Welding said
Jul 9, 2018
Thanks for those tips !
measurements would be helpful
by the way I still need a set of Parisienne badges for the right and left fenders.
I was wondering if anyone has any advice,templates or
great ideas to install fender badges on fenders that dont have the proper holes from the factory
the car is a 67 Parisienne badges are the Parisienne script and the v8 script
left and right front fender
Thank Greg
Get som flat styrofoam, put a sheet of paper on top, tap down firmly, get badge, push down through paper and into foam and voila! A hole drilling guide. Masking tape on car once position marked, use guide, light centre pop, use small drill to start with then drill to size.
I think he may have needed the proper position of the emblems ??
Dale @ NOS
Probably best to get measurments and reference points from an existing car for positioning on the panel.
Thanks for those tips !
measurements would be helpful
by the way I still need a set of Parisienne badges for the right and left fenders.
thanks Greg