Can anyone give me a heads up on the hole size for a 4 spd muncie going in my 66 SD? Please and thank you.
4SPEED427 said
Feb 19, 2023
Are you talking the hole size in the bellhousing or the hole in the floor for the shifter?
66sdguy said
Feb 20, 2023
Sorry, the hole in the floor.
seventy2plus2 said
Feb 20, 2023
I think they reproduce the manual transmission floor hump. If you either have a hump or buy a reproduction, they basically fall into position. Once in position, you can determine where to cut the floor.
Lt1 Burb said
Feb 21, 2023
Just buy the plate and open up as much of the floor as plate covers.
The floor is already opened up but I think the previous owner who started the project cut the hole for a bench seat stick in stead of a hole for a bucket seat car, which is what the car is. I may have to patch the hole to make is smaller.
seventy2plus2 said
Feb 26, 2023
I don't think the hole for bench vs bucket seat card are any different.
Can anyone give me a heads up on the hole size for a 4 spd muncie going in my 66 SD? Please and thank you.
Are you talking the hole size in the bellhousing or the hole in the floor for the shifter?
Sorry, the hole in the floor.
Just buy the plate and open up as much of the floor as plate covers.