Clear coat on translucent sections of the steering wheel?
Neilvermilion said
April 11th
Hey guys, I need a piece of advice. I'm restoring a steering wheel (my second time), I was lucky and my steering wheel turned out with those super cool clear sections underneath the vinyl wrapper. I restored the cracked solid sections, not problems there, but with the clear ones I'm not sure what would make more sense. I want to leave it as is till I find the way to print it with clear resin, but would like tune it up a bit. My question is - should I sand it a tiny bit and apply clear coat? Or clear coat won't stick either way and Is better just to clean it and that's it? Also - any advice on the brown rusty areas? Any magic tricks?
-- Edited by Neilvermilion on Thursday 11th of April 2024 08:53:19 PM
I'll need to make the parchment part much dirtier:)
cdnpont said
April 12th
Man! I'd be happy with that.
Neilvermilion said
April 12th
Ended up like that for now, put clear coat on top of clear sectors to seal the smell coming from the cracks.
I know it's supposed to be black, but it will take some time to bring this ex show car to original colors and I always liked how light steering wheels looked like in classic cars. It will take a day or two to make it black either way. Got the black carpet already.
On that note a question - does the original steering look fawn to you?
What did you use to build up the plastic sections?
Neilvermilion said
April 14th
Fiberglass bondo. If the cracks would be smaller I'd just use JB weld, but unfortunately some cracks were like 1cm wide.
1965CS said
April 14th
I would like to restore mine but the clear is the tough part. Been searching for a transparent epoxy or some type of clear plastic putty, but no luck yet.
Neilvermilion said
April 14th
Theoretically if I knew all precise radiuses (like metal rod torus, the rest I can measure, the amount of bumps I can also count) and precise factory sections lengths (I may adjusted mine a bit here and there) I could just model 2 parts, front and back, then whoever has a resin printer could just print them and glue with something transparent. We will need someone who's willing to sacrifice the wheel, cut out the sections of interest and try and fit the printed result(s).
Hey guys, I need a piece of advice. I'm restoring a steering wheel (my second time), I was lucky and my steering wheel turned out with those super cool clear sections underneath the vinyl wrapper. I restored the cracked solid sections, not problems there, but with the clear ones I'm not sure what would make more sense. I want to leave it as is till I find the way to print it with clear resin, but would like tune it up a bit. My question is - should I sand it a tiny bit and apply clear coat? Or clear coat won't stick either way and Is better just to clean it and that's it? Also - any advice on the brown rusty areas? Any magic tricks?
-- Edited by Neilvermilion on Thursday 11th of April 2024 08:53:19 PM
Damn, it doesn't look as cool as I imagined when one part is restored and the other is original:(
Man! I'd be happy with that.
Ended up like that for now, put clear coat on top of clear sectors to seal the smell coming from the cracks.
I know it's supposed to be black, but it will take some time to bring this ex show car to original colors and I always liked how light steering wheels looked like in classic cars. It will take a day or two to make it black either way. Got the black carpet already.
On that note a question - does the original steering look fawn to you?
What did you use to build up the plastic sections?
I would like to restore mine but the clear is the tough part. Been searching for a transparent epoxy or some type of clear plastic putty, but no luck yet.