2024 Canadian Poncho Calendars are Now Available! CLICK HERE

 

 

Members Login
Username 
 
Password 
    Remember Me  
Post Info TOPIC: new pressure plate has no x mark


Veteran Member

Status: Offline
Posts: 47
Date:
new pressure plate has no x mark


hey my nos pressure plate isnt x marked or anything. my other two old plates have marks by the bolt heads one says G the other has an S. the flywheel has nothing at all and i think its an aftermarket flywheel that will accept two different pressure plates because it has two sets of holes. how do i make sure this stuff is balanced? i did make sure the flywheel was matc marked to the crank however. but the new plate has no marks at all...

 



__________________


A Poncho Legend!

Status: Offline
Posts: 35601
Date:

Interesting     I have used a old pilot shaft to "line up"   never did look for any marks confuse



__________________

 



Veteran Member

Status: Offline
Posts: 47
Date:

i phoned my dad about it and he said that theres no balance mark on the pressure plate because its new and has no wear. hence install as you will but later down the road if you take it apart again make sure to match mark everything because it will have all worn together and you want to maintain that .

__________________


Addicted!

Status: Offline
Posts: 143
Date:

If the flywheel is balanced it will have a few drill holes started in the back side, if no drill holes started then it is not balanced.



__________________
Ron Bedard


Veteran Member

Status: Offline
Posts: 47
Date:

thanks, i made sure to mark the flywheel to the crank before i removed it so thats not a problem. i sure appreciate the advice!


__________________
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to Del.icio.us
.
Support Canadian Poncho!
Select Amount:
<
.
.
.