Anybody have dimensions for the correct trunk emblem placement? My car has a Chevelle trunk lid and I filled the holes when I built the car 15 years ago. Finally found an emblem for the trunk lid. Now I just need to drill the holes in the right spot. Measure 18 times, drill once!
Anybody have dimensions for the correct trunk emblem placement? My car has a Chevelle trunk lid and I filled the holes when I built the car 15 years ago. Finally found an emblem for the trunk lid. Now I just need to drill the holes in the right spot. Measure 18 times, drill once!
I would drill the first hole 2-9/16 x 3-11/16 then line your emblem with that hole and pivot it down until the last hole is around 1-15/16 from bottom edge. And then mark four other holes.
-- Edited by Beaumont4008 on Friday 9th of September 2016 10:29:24 AM
'64 Parisienne CS "barn find" - last on the road in '86 ... Owner Protection Plan booklet, original paint, original near-mint aqua interior, original aqua GM floor mats, original 283, factory posi, and original rust.