hi guys! I'm sure this question has been asked and answered many times on here so I apologize if it's been addressed.
I recently bought a 59 2drht. I am aware that it's on a chev frame and drivetrain but am wondering if there are any American models that have parts that are interchangeable... Mostly side trim, bumpers, front end (grill) and trunk area stainless and such. Also, are the doors and interior the same overall length and size?
When looking at photos it looks like the Catalina is shorter than the Bonniville and may share the same side trim as a Parisienne. All this is a bit confusing but any info would be appreciated.
This page has lots of great info thanks!
What do you need , have same car body is complete sheet metal is rusty bumpers are there,grill most of trim it has power windows and both seats dash radio rear speaker switch,engine and trans,still in car. you can have hole car for donation to site Laurie car is in Manitoba
Hi. I need front and rear bumpers as mine are banged up really bad. Most of my side trim is really rough or missing so I would like to find some that I can work with. The upper and lower grill accent trim is banged up. The 3 rear deck lid trim pieces are very poor cond. and I could use back up light housings and the triangle trim pieces that are above it. My fin trim is pretty wavy too. The car is almost rust free and runs but a lot of the stainless and trim is rough. That is the main stuff I'm after. I honestly don't think I will ever be able to make it out to see or remove parts as I'm in BC. I would be interested in the whole car if I wasn't so far!
Sometimes members are travelling between provinces with a trailer. Perhaps someone could help get this car to a fellow who desperately needs it?
Yep, post an ad (thread) on this site Neon. I might cost you about a G note to ship by someone on here.
__________________
Prince Edward Island
'64 Parisienne CS "barn find" - last on the road in '86 ... Owner Protection Plan booklet, original paint, original near-mint aqua interior, original aqua GM floor mats, original 283, factory posi, and original rust.
Damn! Thanks for the leads! I'm never too far from Alberta. The shipping would be worth it from Manitoba if the car had the parts I needed. Thank you everyone for this info. Sorry it's taken me a bit to get back to y'all. Busy up north at work with poor internet service.