Members Login
Post Info TOPIC: 1957 Pathfinder


Status: Offline
Posts: 4
1957 Pathfinder

Picked up a 57 survivor, four door. Looking at front brakes and found original wheel bearings need to be changed out. The cost of original ball bearing set up is surprising to put it nicely. There seems to be a replacement roller bearing set available if you change out the drums. Short of going the disk brake route has anyone dealt with this. Thanks in advance Due to being off grid for summer months I can only check messages once a week.


Uber Guru

Status: Online
Posts: 3648

Glenn, forget the useless ball bearing set up. Get complete hubs off of (early to mid 1960's Chevrolet's or Canadian Pontiac's of the full size variety.) These hub assemblies have roller bearings and will slide right on with no modifications. Ball bearings are not only very expensive and take no side loads, they also drag. You can buy new roller hub conversions but these are very expensive. Find a wreck or parts car and take the hub assemblies off it, it will be far cheaper that way. That is what i did with my 57 Pontiac 21 years ago at Dom's auto wreckers and the doner car was a 1963 Chev full size. Good luck.

-- Edited by long stroke on Wednesday 9th of August 2017 11:59:12 AM


1957 Pontiac Pathfinder Deluxe sedan restored 261 six

1974 Chevrolet Caprice Estate wagon low milage original 400 V-8

Page 1 of 1  sorted by
Quick Reply

Please log in to post quick replies.

Tweet this page Post to Digg Post to