Could someone send me a good picture of the inner fender splash shields and the staple location for my 69 Beaumont. I have new OEM inner fenders that don't have the holes for the staples. Could you give me the approximate size of the staple as I am going to use stainless wire instead.
Thanks a million Kevin
Paulish said
Jul 6, 2008
Sorry no idea here ...but sweet clock
65Camino said
Jul 7, 2008
There is a guy with a 69 at one of our cruise nights with them. Next time 73SC and me go we'll snap some pictures.
73SC said
Jul 7, 2008
Ya and he even has the A arm seals in place. I looked for the staples but didn't see any last week.
73SC said
Jul 27, 2008
Took a while but we ran into the 69 Beaumont again. It is an untouched 307 car, well he just put on duals but other than that untouched.
Thanks for the pics, but it looks like plastic inner fenders. I have the steal ones , not sure if they are the same at the a arm opening.
Thanks again for your pics and time, much appreciated !
Kevin
73SC said
Aug 3, 2008
Those are steel inner fenders with a rubber A arm seal, held on by staples. I know it's hard to tell and see .
69SD said
Aug 3, 2008
I had plastic inner fenders and they are plastic, if you look close at the drivers side you can see the LH on the top under the wiring harness. The raised LH and RH were only found on the plastic ones .
Kevin
68post said
Aug 4, 2008
Yeah they look like plastic. I just went out and checked my untouched 69, and it's got the plastic inner fenders as well.
How about my 69 SS396? It's got steel inners.
Thanks a million
Kevin