Trim chart shows 731361 as a right and 731360 as a left. but I think they might fit eather side. I will check with the ones I have tomorrow.
Beaumont4008 said
Feb 26, 2010
Just checked my headlight bezels and there are two different part numbers #731361 and 731360. I put them side by side and can not see any differance. If there is a difference I just can not see it.
rabbit64cs said
Feb 26, 2010
the only difference I could see is in the corners where the headlight adjusters would be ,there is a bit of a reveal for access to the screw.
I have 2 of the same part # that was pulled from the same car? so I guess it is possible to use them, just may not be convenient to adjust your headlights?
does that make sense about the reveal ?
thanks..
Beaumont4008 said
Feb 26, 2010
The indents seem to be on the same side of both part numbers. They look the same to me. Strange.
This is 731360
This is 731361
4SPEED427 said
Feb 26, 2010
Often the left and right differ in the cutout for the adjuster screws. It's not that, is it?
Can't tell in the pictures.
Beaumont4008 said
Feb 26, 2010
Front veiw. All the cut outs look the same.
SD 396 said
Mar 11, 2010
The left and right are different. If you are in a bind you may be able to use it. You will find that the curve is different and the retainer screws that hold the bezel don't line up quite right. You will end up breaking the retainer screw clips and probably damaging the paint on the header panel.
57poncho said
Apr 3, 2010
I have on of each if you want PM me and we can talk.
This is 731360
This is 731361
The left and right are different.
If you are in a bind you may be able to use it. You will find that the curve is different and the retainer screws that hold the bezel don't line up quite right. You will end up breaking the retainer screw clips and probably damaging the paint on the header panel.