Well I popped the drivers door off today to put new springs n bushings.

The top one was simple enough. I however cant get the pint out of the lower hinge. The bottom of the pin is all flattened out from some body else's doing. 

Just wondering what you guys  do to change the lower pin n bushings?
I have been searching, but havent come up with anything yet.

Thanks, Jesse

You may have to heat the pin area where it goes through hinge then pound "er' out!! Been in there a few yrs. or so!!!!!!

Well I just popped the hinge of, drilled the old pin out. That it popped right out. Still have to re align the door. Ill have to do it when i I do the body over the winter. But atleast my door shuts good meow.