I replace the front header with a 68 Beaumont new rad support , new drivers side Chevelle fender .
The lower grille on both sides doesn't quite match up. about a 1/4 to 1/2 inch gap.
Not sure why ? I am pretty sure it didn't have a gap before the repaint.
Brian
They probably were 1/4 -1/2 inch in 1969 most restorations have better clearances than new
Yes , I ordered the bracket to weld in place of the new chevelle fender. It has the holes to mount
the end grille extension piece.
Sorry it took so long to reply.
I replace the front header with a 68 Beaumont new rad support , new drivers side Chevelle fender .
The lower grille on both sides doesn't quite match up. about a 1/4 to 1/2 inch gap.
Not sure why ? I am pretty sure it didn't have a gap before the repaint.
Brian
I've been told it is different?? inner structure, may hav an effect an alignment..
just asking?
They probably were 1/4 -1/2 inch in 1969 most restorations have better clearances than new
Yes , I ordered the bracket to weld in place of the new chevelle fender. It has the holes to mount
the end grille extension piece.
Sorry it took so long to reply.