Enjoy 5% OFF at VEVOR Canada! and Support Canadian Poncho at the Same Time!
Members Login
Username 
 
Password 
    Remember Me  
Canadian Poncho Homepage -> Canadian Poncho -> 65-70 Full Size Body Tech Forum -> Drilling holes in good fenders
Post Info TOPIC: Drilling holes in good fenders
SGS Welding


Guru

Status: Offline
Posts: 504
Date:
Drilling holes in good fenders
Permalink  

I was wondering if anyone has any advice,templates or

great ideas to install fender badges on fenders that dont have the proper holes from the factory 

the car is a 67 Parisienne badges are the Parisienne script and the v8 script 

left and right front fender

Thank Greg



__________________

67 Parisienne Convertible 

67 Parisienne 2 Door Hardtop 
hawkeye5766


Canadian Poncho Superstar!

Status: Offline
Posts: 6043
Date:
Permalink  

Put masking tape on area to be drilled(will help with chipping the paint), also works well for marking/laying out where to drill.

__________________
Nov 18 to Dec 2 Black Friday UP TO 50% OFF Plus Huge Coupons
Nov 18 to Dec 2 Black Friday UP TO 50% OFF Plus Huge Coupons
koolconvertible


Poncho Master!

Status: Offline
Posts: 1713
Date:
Permalink  

Get som flat styrofoam, put a sheet of paper on top, tap down firmly, get badge, push down through paper and into foam and voila! A hole drilling guide. Masking tape on car once position marked, use guide, light centre pop, use small drill to start with then drill to size.



__________________

cutting a roof off a four door is NOT a convertible.....

65 Parisienne convertible.one of 49 built for RHD export market,402BBC, T400, 2500 stally, posi rear, upgraded brakes with front discs, FUEL FAST efi custom built by me.
NOS


Poncho Master!

Status: Offline
Posts: 1703
Date:
Permalink  

I think he may have needed the proper position of the emblems ??

Dale @ NOS



__________________
koolconvertible


Poncho Master!

Status: Offline
Posts: 1713
Date:
Permalink  

Probably best to get measurments and reference points from an existing car for positioning on the panel.



__________________

cutting a roof off a four door is NOT a convertible.....

65 Parisienne convertible.one of 49 built for RHD export market,402BBC, T400, 2500 stally, posi rear, upgraded brakes with front discs, FUEL FAST efi custom built by me.
SGS Welding


Guru

Status: Offline
Posts: 504
Date:
Permalink  

Thanks for those tips !

measurements would be helpful

 by the way I still need a set of Parisienne badges for the right and left fenders.

thanks Greg



__________________

67 Parisienne Convertible 

67 Parisienne 2 Door Hardtop 
Page 1 of 1  sorted by
 
Quick Reply

Please log in to post quick replies.
Canadian Poncho Homepage -> Canadian Poncho -> 65-70 Full Size Body Tech Forum -> Drilling holes in good fenders
Tweet this page Post to Digg Post to Del.icio.us
.
Support Canadian Poncho!
Select Amount:
<
.
.
.