Do you have a digital caliper Carl? Can you get me the diameter of the input shaft?
I took trans to Car Quest John measured the shaft for me it was .595 the inside of the National PB-656 is .593! I went to Goderich Napa there only had a 33.00 SKF B657 that "will" just slip on Now (heard another story this morn.) I don't want to use roller bearing..
Dave in Florida told me to sand down the .593 inside bushing to .595 outside of shaft .. I used Dremmel and now the hole in bushing is too big? The roller bearing I bought fits, but now I am afraid of it..... I tried to find a old cut off pilot shaft today to use as a guide (better than plastic one) but no success...