The GM auto's all have a pump driven by the torque converter and you stand to have a seal and bushing failure from no lubrication as the output shaft turns for thousands and thousands of times.
Pull the drive shaft for the trip or rent a uhaul trailer.
The GM auto's all have a pump driven by the torque converter and you stand to have a seal and bushing failure from no lubrication as the output shaft turns for thousands and thousands of times.
Pull the drive shaft for the trip or rent a uhaul trailer.
thanks for the explanation.. I know Power glides pump from the output , hence the can be push started.. just knew it was bad with any Auto to pull over a long distance spinning the driveshaft.
I pulled an old 1/2 ton for an hour once, but it ran so I left the engine idling , while I towed it in neutral, worked OK..
__________________
later...rog
AADD supporting member !!
I'm a collector...not a builder!!Located in sunny central Saskatchewan at the lakehead!
Decades ago I towed cars with a custom tow bar, probably 35 times (Chevelle/Beaumont/Corvair's mostly).
- if it was only several miles, I often let the motors idle in the neutral gear
- over long distance (like 2 hours), removing the drive shaft is a must...or the transmission will overheat and all the oil will leak out
5 years ago I borrowed a car dolly to tow a 1996 Jeep Cherokee (RWD, originally a Florida vehicle purchased in Ontario).
- I backed the SUV onto the car dolly, so the back wheels and drive shaft would not turn, being elevated off the road way
- next roped off the steering wheel (through both door handles), maintaining a straight steering wheel position (fixed front wheels now trailing on the rear of the tow rig)
^^^^ Towed the 2 wheel drive Jeep for 2 hours straight, without any problem (drive train remained perfect).