realllll longshot but looking for a few needle in the haystack things I still need for my restoration. Still doing extensive sheet metal restoration , so I have some time, but some of this stuff is hard to get now. Parts are for an original (Canadian Chevrolet) car if that matters, not a clone.
BB frame mounts (both sides) got them now
BB carb linkage rod (carb to arm)
BB 4 speed driveshaft (have not investigated driveshafts yet so not sure if this is special or not)
331 12 bolt gears and eaton posi.
1968 "JK" wheels. I have a few but missing two(need one for spare as well) and one is pretty rusty.
An oe trunk jack assembly that I can restore got this now
A correct 1968 thermactor black lid air cleaner with the 90 degree spout, as well as the heat stove tube and parts. I do have a complete original 4 speed cleaner (no thermal) but for canadian built cars they apparently used the thermal.
Any blue std belts for a 68 biscayne
-- Edited by blkl36 on Saturday 29th of April 2023 01:56:34 PM
For the frame mounts, there is some hope because as this page shows, the later production 68 full size Chev/Pontiac used the same frame mount on the 327 4 bbl.
Yes the mount thing makes sense because the early mounts were obviously weaker for the toque of the more powerful engines and maybe that's why they came out with that engine limit contraption to bridge the gap before going to beefier mounts with safety locks (the wider ones if I'm not mistaken)
I have a couple 1968 dated 14x6 JK rims I dont need. I will dig them out.
I also have a very clean, no pitting 4 speed cross member for a 1968 4 speed car if you need?
__________________
1967 2dr Biscayne. L36, M40, G80, K05, F41. #'s. 1967 Impala convert. 283, glide. Parked in the garage since 74 and hasn't moved. Soon to be BB 4speed.