bob, i put a southwest usa '70 frame under my bel air. frame had a couple 'minor' patches done to it. i found other areas were thin and a hole through the top rail near the rt rear control arm. my thoughts were if one or two areas are thin, what about the areas you can't see? the frame i found was absolutely rust free, still had the original factory coating on it.
don't know of anyone building new frames.
check my bel air site for the pictures.
-- Edited by 69 belair on Monday 27th of July 2009 07:55:49 PM
From experience......... Not all western cars have good frames either! The last 5 I dragged home from Sask, Manitoba and Alberta and BC, only 1 Sask car seems to have a good one!!! Just depends on the owner....
Sounds like someone with some time, a truck and a good trailer could make a few bucks bringing some frames back from the south. Now's the time to do it with scrap prices so low.
yes the west may not be the place for frame hunting,my 65 impala has been patched up and several parts cars i have gotten have frame issues.This is also true with my 65 sd parts car and my 64 custom parts cars both have frame isssues. imbuk
northern SK frames of cars that were parked in the 70's are usually nice and sound .. before they started salting the crap out of the roads and winter tires were not 'seasonal'
It doesn't make sense to bring one out east....or does it??
__________________
later...rog
AADD supporting member !!
I'm a collector...not a builder!!Located in sunny central Saskatchewan at the lakehead!
If the frame is really soft all over, just buy a replacement. I spent a good bit of time repairing mine, but I knew a welder with a shop and a pro tig machine. So it was done well. But unless you can ultrasonically test the thickness, how do you really know what areas have enough meat to be safe. We hammer tested everything and did it by sound more or less to find the soft spots. Essentially the bottoms and outboard sides of my frame rails, and partially up the doglegs were soft. If I did it all again....
In my experience the best bet is a used frame from the US sunbelt, or northern Canada. I had a 69 Biscayne 2 dr post car that came from Arizona via Ontario and Nova Scotia. The body was good but I had to replace the rusty frame. The one I used came from a 68 Biscayne wagon out of Labrador, that was solid except that I had to weld in some reinforcements under the body cushions.
I have a spare frame now that came from a 69 Caprice 4 door ht. The car was a 350/300 HP small block from North Carolina, had HD suspension, disc brakes and a 12 bolt rear end. Although the car was in Newfoundland for 15 years when I bought it, the frame was rock solid, as were the floors, rockers and most of the body panels. The exceptions were the quarters, the hood and the roof (a seive, resulting from corrosion under the vinyl top).