|
STICKY:
Standard 69' Cluster to Rally. Plug wiring diagram.
(Preview)
I've traced both clusters and have made up two diagrams of the plug wiring. The first shows the original 1969 Full size Pontiac standard instrument cluster configuration, with the Rally cluster to the right. The Rallys wiring is likely unique to the USA car, athough it is possible Canadian Cars w...
|
cdnpont
|
17
|
13045
|
|
|
|
Installing LED's in the '69 rally gauge cluster
(Preview)
I have pulled the dash cluster out of the '69, to convert the ammeter gauge in the rally cluster. In addition, I thought I would put #168 LED's in the cluster. I know someone has done this before and posted on here, I thought it was Mark (Cdnpont), but it wasn't. My question is how do I determine polarity of...
|
gtodrive
|
13
|
357
|
|
|
|
Adhesive or Tape Recommendations
(Preview)
So, when I restored the interior on my 69 2+2, I installed an NOS trim plate that mounts on the instrument cluster. It had the factory adhesive tape on it, and over the last few years, has lifted off at the edges. I removed it and cleaned the adhesive off the cluster and the trim piece. I am ready to reinstal...
|
gtodrive
|
10
|
269
|
|
|
|
B-Body Speedometer Type Font
(Preview)
Random question, but I want to do some number stenciling on my 69 2+2 which I converted to the US rally gauges. I am converting the ammeter to a volt meter and want to stencil some reference numbers on the face. So, does anyone know the type font name that was used for the speedometer numbers?
|
gtodrive
|
4
|
202
|
|
|
|
1965 B. Heaterbox floor deflector question,
(Preview)
Is the 65 B vent supposed to have another clipped on passenger side deflector? Looks like there is a provision for it to the right side of the deflector. If yes, does anyone have one?
|
cdnpont
|
6
|
192
|
|
|
|
Help behind the Dash. Wiper button problem. 66 Bonneville
(Preview)
Hey guys, Need some help/advice on this one. I went to push the button for the washer/wiper to go on. And everything from behind fell out? It looks like a pin came out, and so the button is pushed in and the knob just spins... Do I have to take the whole dash off? how do I assemble what fell out back together? ...
|
mike667
|
6
|
192
|
|
|
|
Tachometer in dash
(Preview)
Hello ,new to the form ,recently purchased a 1967 Beaumont Convertible just wounding if it was available with a in dash tachometer. If so where would I start to look for one thanks stay safe
|
67-Beaumont
|
7
|
303
|
|
|
|
|
65 B Body column bearing, excess play. And a horn contact question.
(Preview)
I've replaced the upper bearing in the 65 column, and there is at least 1/8 of up and down play in the wheel now. Looking at the shaft as it passes up through the bearing, it's tight on the inner race, the outer race is seated in the switch housing solid as well. The bearing is super sloppy between the races....
|
cdnpont
|
10
|
261
|
|
|
|
67 Parisienne convertible spare tire hold down kit?
(Preview)
Can anyone take a picture of their trunk for me? All I have is a full size spare and a bumper jack, I can only assume these pieces are correct?? I think Im missing a J hook a big wing nut , spacer washer for center Of rim ,jack handle lug wrench? Any help is appreciated thanks Greg
|
SGS Welding
|
3
|
264
|
|
|
|
Fraser Lk BC
(Preview)
Hi is there a member here on our site close to Fraser Lake BC/Prince George area? Could use a good set of car guy eyes to look over a 1976 El Camino Classic. Its a California car when new been up here a few years barn kept, should be decent. You would be dealing with an 80 year old Grandma on my behalf, price is...
|
carnut70ls4
|
4
|
489
|
|
|
|
Canso
(Preview)
Is there any source for 66 canso interiors? Id prefer not to go Nova and prefer not to get used worn out stuff (I already have that). Any upholstery shops that can duplicate or repair/renew what I have?
|
noorticus
|
2
|
373
|
|
|
|
Here are instructions on removing radio and glove compartment
(Preview)
Hello Since there are no posts on this I decided to start one. This is for a 67 Parisienne with the standard AM radio, no factory A/C or tape deck. 1. OPTIONAL: remove glove compartment door and left hinge that stops door at horizontal position. Removing door will make the light stay on but also gives yo...
|
Leo2+2
|
2
|
309
|
|
|
|
How to remove the radio from a 67 Parisienne
(Preview)
Hi there I want to remove the radio. There's a hex screw on the right side holding it together to a brace next to glove compartment box. It's nearly impossible to reach. Any hints on how to remove it including how to properly remove the glove compartment box if easier to access through there?
|
Leo2+2
|
7
|
422
|
|
|
|
Fusebox picture
(Preview)
66 Canadian Pontiac fusebox picture for a member who requested it:
|
4SPEED427
|
13
|
463
|
|
|
|
|
AM FM Radio for 68 B Body
(Preview)
Just a question here but will a 7303302 am fm radio that lists for usage in 67 68 Catalina / Grand Prix etc fit the CP? -- Edited by 68 Grande on Tuesday 5th of May 2020 01:29:34 PM
|
68 Grande
|
3
|
548
|
|
|
|
dash pad removal
(Preview)
hi guys has anybody removed 69 dash pad !is it very difficult !its faded and chunks off it missing !i always believed my moms chihauhau bit them off 40 yrs ago ! but were not sure !
|
danny06
|
12
|
593
|
|
|
|
Antenna lead in 1965. Where does it enter the car?
(Preview)
Question; Where does the antenna lead in come into the car? My 65 was radio delete, and whoever installed the radio/antenna just ran the lead through the right kick vent opening. I suspect I'll have to find a creative spot as the fenders are staying on, but I'm just curious. Thanks, Mark
|
cdnpont
|
3
|
326
|
|
|
|
1968 pontiac catalina headliner rods
(Preview)
I removed the rods 10 years ago. Cleaned and painted them, but forgot to label where they can from. there are 5, (1) 1/8 thick and (4) 1/4 inch thick.
|
tramminc
|
4
|
351
|
|
|
|
Exposing the Shoulder Seatbelt Anchors Points under the Headliner in 68
(
1 2
)
(Preview)
I have been considering upgrading the seat belt system for the driver and passenger in the 68 to a 3 point system with a retractable shoulder restraint. I believe in the 68's there was an option for the shoulder strap but the anchors were factory installed in all cars whether you took the 3 point or the 2...
|
68 Grande
|
33
|
881
|
|
|
|
67 parisienne carpets
(Preview)
Will the carpets for the 67 impala on rock auto fit in my parisienne? (4 door) Are there any other sites to buy parts from that will work in my car? I also need a vent pull for the driver side.
|
Riddler
|
3
|
411
|
|
|